Console Port; Port Connections; Summit 300 Automatic Failover - Extreme Networks Summit 200-24 Hardware Installation Manual

Table 11: Summit 300-48 switch LED behavior
10/100 Mbps Port Status LEDs
Color
Green, solid
Green, fast blinking
Amber, solid
Amber, slow blinking
Amber, fast blinking
Alternating amber/green
Off
10/100/1000 Mbps Port Status LEDs
Color
Green solid
Green blinking
Summit 300-48
A
switch
mber blinking
Off
Fiber Port Status LEDs
Color
Solid Green
Blinking Green
Off

Console Port

Use the console port (9-pin, "D" type connector) for connecting a terminal and carrying out local
management.

Port Connections

The Summit 300-48 switch uses a combination of 10BASE-T/100BASE-TX ports using RJ-45 connectors
and Small Form Factor Plugable (SFP) Gigabit Interface Connectors (GBICs), also known as mini-GBICs.
Ports 1 through 48 are 10/100 ports with RJ45 connectors.

Summit 300 Automatic Failover

The Summit 300 switches provides dual-media support on GigE ports. On the Summit 300-24, ports 24
and 25 are Gigabit Ethernet ports that have redundant PHY interfaces, one mini-GBIC and one
Consolidated "e" Series Hardware Installation Guide
Indicates
Link is present and port is enabled; non-powered device.
Port is enabled; link is up, device non-powered and activity on the
port.
Link is present and port is enabled; device powered.
Link is down or port is disabled; device powered.
Port is enabled; link is up, device powered and activity on the
port.
There is a power fault.
The link is down or the port is disabled; non-powered device.
Indicates
Link is present; port is enabled; full-duplex operation.
Link is present; there is activity.
Reserved.
Link is not present or the port is disabled.
Indicates
Link is present; port is enabled; full-duplex operation.
Link is present; there is activity.
Link is not present; port is disabled; mini-GBIC is not installed.
Summit 300-48 Switch
51