Verify The Installation - Extreme Networks BlackDiamond 6816 Upgrade Manual

NOTE
An MSM-3 will not operate with ExtremeWare versions prior to 7.1.1 or BootROM versions prior to
8.1. If you inadvertantly load the wrong ExtremeWare or BootROM image, upgrade the master
MSM64i to the correct images and synchronize again.
5 Force the MSM64i to fail over to the MSM-3 using the
6 Remove the MSM64i that has just become the slave.
7 Install another MSM-3. It initializes as the slave MSM.
8 Copy the upgraded ExtremeWare, BootROM, and configuration from the master MSM-3 to the slave
MSM-3 using the

Verify the Installation

After you install an MSM-3, verify that it is working correctly by checking the LEDs on the front panel.
If the MSM-3 is operating normally, the front-panel LED indicators appear as follows:
• SYS LED—green blinking
• MSTR LED:
— Green: Operating as master
— Amber: Operating as slave
• ENV—green
• ERR—off
• Link/Activity:
— Green: Link is up
— Amber: Packet activity is occurring
MSM-3 Upgrade Note
command.
synchronize
command.
run msm-failover
Upgrade Your Chassis
3