Matrox Maevex 5100 Series Release Notes page 5

message will be displayed if any of these options are in use and have to be
disabled before enabling protected content support. [3235]

Streamed protected content can be displayed on a maximum of 32 remote
displays (or less if HDMI repeater or splitter devices are used to connect the
displays to the Maevex 6152 decoder devices) but may be limited based on
the source's capabilities and limitations.

Streaming over WAN of HDCP protected content is not supported. [3110]

When protected content is enabled, on rare occasions, some HDCP displays or
sources may not reinitialize properly after disconnecting and reconnecting the
display device or following the reboot of a Maevex encoder device, resulting
in a black or snowy pass-through display and/or stream. If this occurs, power
cycle your display, or disconnect and reconnect your HDMI cables, or reboot
your Maevex device again. [ 3372, 3378]

If HDMI EDID pass-through is disabled in PowerStream Plus, with or without
a local display being connected, the Maevex device may not detect the HDMI
source following a reboot. If this occurs, disconnect and reconnect the HDMI
cable from the source, or enable EDID pass-through and reboot your Maevex
device. [3290]
Maevex 6100 Series Encoders

Following an input signal interruption or switching, the
on signal loss
mode or signal frequency change. In the event of an input mode change, the
outgoing stream will be torn down and regenerated, resulting in a decoder
disconnect and reconnect event.
 Can't record to an IPv6 link-local address. [1791]

HLS has a limited and fixed list of frame sizes. For more information, contact
your Matrox representative [1691].

Depending on the analog audio input voltage level from the analog audio
source, clipping (audio distortion) may occur in the stream and headphone
out, especially at higher or maximum (6dB) audio input level setting from
PowerStream Plus. To avoid this, reduce the analog audio level from the
source, from PowerStream Plus, or from both.

Recording to extFS (ext2/3/4), NTFS, and FAT32 drives is supported
(exFAT-formatted drives aren't supported).
1
Tracking reference number
®
Matrox
feature requires that the input signal recover without an A/V
Release Notes – Matrox Maevex™ 6100 Series and Maevex™ 5100 Series
®
Continue streaming
1
5