Matrox Maevex 5100 Series Release Notes page 10


If failsafe is enabled (decoder), the feature overrides source-to-destination on
signal DPMS remoting.

USB and SD

Certain non-Matrox graphics cards may not properly support certain
resolutions. For example, they don't output full-screen images in a
1920 × 1080 resolution (you can replicate this connecting your display
directly to your graphics card). For information on the capabilities of your
graphics card, contact your graphics hardware manufacturer.

Your Maevex devices can only be detected on a DHCP network. To locate a
Maevex device outside the DHCP subnet, first detect the Maevex device on
the subnet, then set the Maevex device to a fixed IP address known to be
available on the LAN outside the subnet. Remove the Maevex device from the
subnet and place it in the intended location on the LAN.

Multicast streaming requires networking hardware that supports multicast and
is properly configured for IPv4 multicasting. Otherwise, only unicast
streaming will be supported.
 Switching between dynamic and static IP addresses isn't supported while
encoding or decoding. Before you change the IP address, make sure you stop
encoding or decoding.

When switching between the
output methods on the encoder, the source system's HDMI
be disabled. To re-enable the HDMI digital audio, disconnect and reconnect
the HDMI input cable on the Maevex encoder.

To ensure compatibility with auto-negotiating network switches and routers,
your Maevex devices use auto-negotiation for their network speed and duplex
settings. We recommend you configure the networking hardware your
Maevex product is connected to so that it also auto-negotiates these settings.
We also recommend you make sure the speed and duplex settings of your
Maevex devices and networking hardware match. If image corruption occurs,
make sure your networking hardware (and the ports connected to your
Maevex devices) isn't overloaded and dropping data packets. If necessary,
increase the bandwidth allocated to the ports connected to your Maevex
devices, or try using different ports.

Connecting a networked device other than a Maevex decoder (such as a
computer, networked display, etc.) to the second network port of a Maevex
decoder is currently unsupported.
 If you're using
system may not output a valid signal, making capture impossible. To resolve
this issue, we recommend trying one of the following:

Release Notes – Matrox
®
10 Matrox
®
Card connectivity are not supported.
Pass through
Use the
Confidence preview
Maevex™ 6100 Series and Maevex™ 5100 Series
®
and
Use pass through
mode without a local monitor present, the source
mode instead of the
Use confidence preview
®
digital audio may
Pass through
mode.