Matrox Maevex 5100 Series Release Notes page 7

Maevex 6100 Series Encoder Appliances

While recording to local or network storage, no warning appears if device is
full or near full. Make sure there's enough available space on the destination
device (USB-based storage or network-based storage) before starting to
record. If the last recorded file is larger than the available space, the recorded
data will be lost.

After connecting a new local DisplayPort console display, the Maevex device
must be rebooted for the DisplayPort output to be enabled.

If the resolution on the DisplayPort preview output is higher than Full HD
(determined by the connected monitor's preferred resolution), the preview
frame rate will be limited to 15 fps. This is done independently from the
streamed or recorded frame rates, which will remain unaffected.

To be able to record to
your LAN2 recording destination. Depending on the IP address of the
recording destination, the data will be sent on the

The control buttons (on the front of the device) assigned for the start/stop
functionality of the recording can control only manual recording. Stopping a
scheduled recording must be done through PowerStream Plus.

The maximum scaling and compositing capability of the device is 4x 4k30 or
2x 4k60 (or equivalent). This includes compositing and scaling for the
purpose of streaming or recording, and for monitoring through the local
DisplayPort preview output (if enabled). The
option, if enabled, also relies on the compositing engine. In case of
loss
processing overload, frame drop and/or image flicker may occur. This can be
avoided by using configurations that limit the number of simultaneous
compositing and scaling processes, or by reducing the frame rates or the
highest resolutions being used. [2833]
Note: In particular, the DisplayPort preview output, if enabled in
quadrant-view, will consume a non-negligible amount of scaling and
compositing processing power that should be accounted for. [2727, 3174]
M aevex 6152 Decoder
1 1 0

If protected content support is enabled in PowerStream Plus on a given
device:


®
Matrox
LAN2
All HDMI outputs will be HDCP protected and non-HDCP display
devices will not receive any signal.
The decoder will decode protected streams originating from Maevex
6152 and 6122 encoders enabled for protected content support, as
Release Notes – Matrox
, make sure to specify a unique IP address for
Continue streaming on signal
Maevex™ 6100 Series and Maevex™ 5100 Series
®
or output.
LAN1 LAN2
7