Matrox Maevex 5100 Series Release Notes page 9


Authenticated stream credential information (such as password and
passphrase) are not saved into the decoder configuration files. Authenticated
RTSP and SRT streams have to be manually added to the stream list and
remapped by dragging and dropping them onto the desired output surface.
Reloading previously saved decoder configurations that contain an
authenticated stream is not supported and would result in a red decoder device
tile in PowerStream Plus. It is recommended to remove streams with
authentication prior to saving any decoder configuration for later use. [3217]

Only NTFS-formatted external USB drives are supported. [3293]

Wake-on-LAN (WOL) through PowerStream Plus is not supported for
devices using DNS host names. [3218]

Some security scanner software may incorrectly report the CVE-2021-23839
and CVE-2021-23841 vulnerabilities in spite of fixing these in this release (by
implementing fixes from Open SSL version 1.1.1).

The Messaging Overlay System supports text messages of maximum 1000
characters at a font size up to 256, or a maximum of 250 characters at a font
size of 512. [3169]

If protected content is streamed through the LAN2 network port of a Maevex
6152 or 6122 encoder device, the stream will not appear on the Maevex 6152
decoder's auto-generated list of available streams. A corresponding custom
stream needs to be created and the stream URL added manually on the
decoder side in order to decode the protected stream. [3281]
M aevex 5100 Series
B

This firmware package includes firmware version 1.05.09.001 for Maevex
5100 Series devices.
 PowerStream Plus – If a password that's longer than 8 characters is set for a
Maevex 5150 device, older PowerStream versions (1.05.03.007 or older)
won't be able to control these devices. Before downgrading from
PowerStream Plus to PowerStream, we recommend first changing the
password to set a shorter password (8 characters or less).

Before daisy chaining your decoders, make sure each decoder is powered.
This enables the decoder's internal network loop, allowing the DHCP server
to allocate an IP address to the daisy-chained decoders.

Audio distortion may occur if the analog audio input voltage level is too high.
If this occurs, we recommend reducing the analog input signal voltage level
from the host system (turn down the input volume).

HDCP (High-Bandwidth Digital Content Protection) is not supported.
 You can't stream and record at the same time (encoder).
®
Matrox
Release Notes – Matrox Maevex™ 6100 Series and Maevex™ 5100 Series
®
9