5. Your existing telephone line can now be inserted into the telephone line splitter.
(Fig.3a/b)
6. Connect the AC adaptor to the DC 9V jack on the auto-dialer. (Fig. 3c)
7. Wall mount option: Check range of both units before permanently installing. Choose
a suitable location, drill holes and install anchors and screws. Place the auto-dialer over
the screws and slide it down to secure it in place (fig 4).
SYSTEM AUTO-DIALER SET-UP
During any set-up, if no key is pressed for 10 seconds, the auto-dialer will automatically
exit set-up mode.
All set-ups must be done in DISARM mode only. (the word ARM will not appear on
the screen)
Your auto-dialer has a factory preset password of 0-0-0. This can be changed to your
own personal password.
1. TO SET PASSWORD
a. Enter factory pre-set password 0-0-0. Press PROG
PASSWORD will flash on the auto-dialer screen. (Fig.5)
button once (1),