Ideal Security SK642 Owners Manual And Set-Up Manual page 14

The water detector included in this package has already been learned to the auto
dialer in zone 1. You may learn additional sensors to your auto-dialer or you can move
the water detector to another zone, and at some time you may have to re-learn existing
parts.
The system has a total of 10 on screen zones for wireless sensors and remote controls.
Zone 1-7: Learn up to 7 wireless sensors, and they will trigger the dialer in armed mode
only.
Zone 8S: Learn up to 8 wireless sensors and they will trigger the dialer in armed mode
only.
Zone 24H (24H standby mode): Learn 8 wireless sensors and they will trigger the auto
dialer in armed or disarmed mode.
Zone REMOTE (LCD icon REMOTE) is the remote control zone and you can learn up
to 8 remote controls. (Ideal Security part # SK629 ONLY)
You can learn a total of 23 sensors and 8 remote controls to this unit.
Each new sensor or remote must be learned to the auto dialer. Follow the following steps.
a. Enter your password and press the PROG button three (3) times.
b. The "LEARN" icon will flash on the screen. (FIG.7)
c. Press ARM/DISARM
code mode and zone 1 icon will flash
d. Press the */UP
learn your sensor to. When the screen flashes NO ID CODE, that means that
zone is empty and you can learn a sensor. If the screen flashes FULL then you
already have a senor learned to that zone. You can either choose another zone
or press DEL./PAUSE
sensor.
e. Press ARM/DISARM
to be.
f. Trigger the sensor or remote control that you are trying to learn as follows:
1. Wireless motion detector SK615, by moving hand in front of
2. Wireless door/window sensor SK621 & SK625, opening and
3. Wireless water alarm sensor SK616, put sensor in water to trigger
4. Wireless temperature sensor SK627, by pressing the test button.
5. Remote control SK629, pressing any key will trigger and send a
6. Garage Alert SK623, opening the garage door will trigger and send
to confirm, the system will go into learning ID
and #/DOWN
to delete the sensor in that zone and learn the new
to confirm that this is the zone you want the sensor
sensor to send signal.* please see NOTE below
closing the magnetic switch will send signal.
and send signal.
signal.
signal.
buttons to select the zone you wish to