Panic Button - Ideal Security SK642 Owners Manual And Set-Up Manual

a. Enter password followed by pressing the Home button.
b. Zone one will flash on the LED screen.
c. Using the */UP
change the setting for.
d. Press ARM/DISARM
#/DOWN
confirm.
e. Press the Home button once to exit home-setup.

5. PANIC BUTTON

a. If you press "PANIC"
learned) the ALARM will sound instantly for 30 seconds, then off for 30 seconds,
then on for 30 seconds and then off, and the auto-dialer will begin dialing the
stored numbers immediately, in either ARM or DISARM mode. If siren is set to
OFF you will hear 4 short beeps at the auto dialer and it will start dialing.
b. To stop the alarm sound and the dialing, enter password then press
ARM/DISARM
6. REMOTE CONTROL BY TELEPHONE OPERATION. (What you can do when
you receive a call from the system)
How to respond to a telephone alarm call.
a. Answer the call. You will hear one of the following:
1) 1 beep cycles is for zones 1-7 and 8S
2) 2 beeps cycles is for zone 24hr
3) 4 beeps cycles is for PANIC
b. You may enter the following codes on your phone key pad. Once code is entered
you will hear a beep for confirmation.
 Function
 To Monitor Room
 To End the Call
 To DISARM the System
7. REMOTE CONTROL BY TELEPHONE TO CONTROL ALARM (To control
your auto dialer via telephone) (see ANSWERING MACHINES and REMOTE
COMMUNICATION)
a. Dial your home number (from anoher line). The auto-dialer will answer after the
designated amount of rings that you have programmed.
b. Once answered enter your PASSWORD, you will hear two beeps (confirmation).
c. Enter key combination listed below for desired function you would like to
perform.
 Function
 To Monitor Room
and #/DOWN
button to confirm. Then using the */UP
buttons select ON or OFF. Press ARM/DISARM
button on the auto-dialer or remote control
button or press the DISARM
buttons select the zone you want to
button on the remote.
Press Keys
1#
3#
6#
Press Keys
1#
&
button to
, (if