View Function - Ideal Security SK642 Owners Manual And Set-Up Manual

 To ARM the system
 To DISARM the System
ROOM MONITOR – Enter "1#" after the beep, you will be able to listen into the room
where the auto-dialer is installed. After 30 seconds you will hear a beep to remind you
that if you do not enter another code within 20 seconds the call will end. The total
duration of the room monitor is 50 seconds if no other codes are entered.
ARM SYSTEM – Enter "5#" after three short beeps the system is ARMED and will
automatically hang up. If you hear 5 rapid beeps after three short beeps, it means one of
your sensors isn't closed or is activated. The system will give you 5 seconds to DISARM
system. If you don't DISARM the system it will start dialing your preprogrammed
telephone numbers. If siren is set to on, it will ring.
DISARM SYSTEM – Enter "6#" after a beep the auto-dialer will disarm and hang up.
NOTE: If you receive an alarm call or you call the auto dialer, and you enter a
wrong password or operation code, the call will disconnect and sound 5 beeps on the
auto-dialer. If the call was an alarm call to you, you can wait for it to call you again
(providing you have the dialing sequence set to more than one) and then enter the
above codes again. If your dialing sequence is set to one and you have set up the
auto dialer to answer before your answering machine (if you have one connected)
then you can call into the auto dialer and enter in your codes again. If you made the
initial call to the dialer you just have to redial and then enter the codes above again.
BATTERY LOW LED INDICATOR
When the Battery Low LED flashes once every 1.5 seconds. This indicates that the
battery in the auto-dialer must be replaced. If a zone # also appears on the auto dialer
screen it indicates that the sensor in that zone is also low and must be replaced. The
indicator on the water detector will also flash every 3 seconds when its battery is low. If
batteries are low, a false signal may be triggered and the auto dialer may start dialing.

VIEW FUNCTION

View Triggered Events
If alarm has been triggered it will flash on the LED screen. To view, in standby mode,
press #/DOWN
will disappear from the screen.
View stored telephone numbers
In standby mode, press */UP
NOTE: If no buttons are pressed for 10 seconds, the auto-dialer will automatically exit
view mode.
TO LEARN ADDITIONAL WIRELESS SENSORS OR REMOTE CONTROL
CODES.
button to view the last 5 triggered Events. Once viewed, TRIGGER
to view stored telephone numbers.
5#
6#