Important Safety Tips; Description Of Components - Ideal Security SK642 Owners Manual And Set-Up Manual

Wireless water alarm system with auto dialer
Table of Contents

Advertisement

Available languages

Available languages

If you intend to use the "REMOTE ACTIVATION" features (controlling the alarm unit
remotely), you cannot use an answering machine in the usual way.
To use the remote activation feature: Set the auto dialer to respond (pick up) before your
answering machine responds. For example, if your answering machine is set to pick up
after 5 rings then set the auto dialer to pick up after 3 rings, this way your AUTO
DIALER will pick up first, allowing you to enter your key selection.
Complete instructions on
setting up the remote activation follow.
If the answering machine is required, then the remote activation feature cannot be used.
Set the auto dialer to respond after your answering machine normally responds (set it to
10 rings) this will ensure that the answering machine is the first response.
INTRODUCTION
Our unique Wireless Water Alarm System with Auto dialer will provide you with early
warning which may reduce the risk of water damages. Choose a location where water
leaks or infiltration may occur to install the wireless water sensor, and a desired location
for the auto-dialer, (near electrical outlet and telephone jack) set the auto-dialer at ARM
mode. Once water is detected, the auto-dialer will turn on the built-in siren (optional) and
dial out the pre-programmed telephone numbers one by one, for the pre-programmed
cycles. You can set the auto-dialer to HOME mode, you will hear one chime only when
water is detected and the zone 1will flash on the display screen. The screen will reset
itself after 5 minutes. System will not dial out.

IMPORTANT SAFETY TIPS

1. Do not install the system where it will be exposed to direct sunlight or rain.
2. The built-in siren is very loud, never put the system close to your ear.
3. The system should be installed away from heat sources such as radiators, heating ducts
and stoves.
4. If the system sounds at random, it is possible that the installed location is too close to a
heat source, changing the location or direction of the unit can correct the problem.
5. The system will provide early warning protection for your home and property from
water damage if you use it properly. However, this system cannot guarantee protection
against water damages. Ideal will not be responsible for any losses or damages occurred
during use of this product.

DESCRIPTION OF COMPONENTS

1. Antenna Jack
2. Telephone LINE Jack
3. Antenna
(antenna is fixed do not try to remove)
4. Battery Low LED
5. Ex Power LED
6. LCD Display
7. Numerical Keys

Advertisement

Table of Contents
loading

Table of Contents