Table of Contents
Advertisement
FAULT
Your machine does not start.
Your machine does not
intake water.
FAULT
Excessive foam is formed in the
detergent drawer.
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
settled unevenly.
Your machine rests on a
hard surface.
POSSIBLE CAUSE
It is not plugged in.
Fuse blown.
Electricity cut-off.
Start/pause button not
pressed.
Programme knob 'stop'
position.
The machine door is not
completely closed.
Water tap is turned off.
Water inlet hose may be
twisted.
Water inlet hose
clogged.
Valve inlet filter clogged.
The machine door is not
completely closed.
POSSIBLE CAUSE
Excessive amount of detergent
used.
Wrong detergent used.
-29-
recommended and settle
the laundry in the machine
evenly.
Prevent your machine from
resting on hard surfaces.
REMOVING METHODS
Plug machine in.
Replace the fuse.
Check mains power.
Press on start/pause
button.
Switch the programme
knob to the desired
position.
Close the machine door.
Turn your faucet on.
Check water inlet hose.
Clean water inlet hose
filters.
Clean the valve inlet
filters.
Close the machine door.
REMOVING METHODS
Press on Start/Pause button.
To eliminate foam formation,
mix a spoon of softener with
half litre of water, and pour the
mixture in the detergent drawer.
After 5-10 minutes, press on
Start/Pause button again. For
next washing operation, decide
the dose of detergent as
required.
Use detergents produced only
for automatic washing
machines in your machine.
Advertisement
Table of Contents
