Clutch Solenoid - Toro Greens Aerator Service Manual

Clutch Solenoid

The clutch solenoid is used in conjunction with the trac-
tion interlock switch, the coring head switch assembly
and the interlock lever switches in the Greens Aerator in -
terlock system. When the clutch solenoid is energized,
the solenoid plunger rotates a latch which retains the
traction drive lever in the engaged position for continued
traction drive operation as long as the solenoid is ener-
gized.
Testing
1. Make sure engine is off. Disconnect battery. Unplug
solenoid from machine wire harness.
2. Apply 12 VDC directly across the clutch solenoid
connector terminals. The solenoid should click and the
solenoid shaft should retract. The shaft should stay re-
tracted as long as the voltage is applied to the terminals.
3. Remove voltage from solenoid coil posts. The sole-
noid shaft should extend.
4. Replace clutch solenoid if necessary.
5. Reconnect electrical connections to solenoid.
6. Reconnect battery.
Electrical System
3
1. Clutch solenoid
2. Latch
5
1. Clutch solenoid
2. Adjusting rod
3. Ball joint
Page 5 – 12
2
Figure 15
3. Traction drive lever
1
2
4
Figure 16
4. Latch
5. Traction drive lever
Greens Aerator
1
3