Transaxle - Toro Greens Aerator Service Manual

Transaxle

28
1. Transaxle
2. Elbow
3. Oil tube
4. Pyramidal washer (4 used)
5. Cap screw (4 used)
6. Set screw (2 used per sprocket)
7. Cap screw
8. Lock washer
9. Thrust washer
10. Key
11. Sprocket
Removal (Fig. 7)
1. Park machine on a level surface, fully raise coring
head, stop engine and remove key from the ignition
switch.
2. Raise lock–up brackets on each side of machine and
lower coring head until it rests on brackets.
3. Remove brake caliper from machine (see Brake Cal -
iper Removal in Service and Repairs section of Chapter
6 – Chassis).
Drive Train
27
16
29
30
8
31
1
12. Taper lock bushing
13. Pulley
14. Lock washer (3 used)
15. Cap screw (3 used)
16. Woodruff key
17. Cap screw
18. Oil plug
19. Pyramidal washer
20. Shift lever assembly
21. Knob
24
22
25
26
23
2
Figure 7
4. Remove drive belt from machine (see Traction Drive
Belt Removal in this section).
5. Remove drive chain from both transaxle sprockets
(see Drive Chain Disassembly in this section).
6. Pull knob from shift lever.
7. Support transaxle to prevent it from falling.
Page 7 – 8
FRONT
RIGHT
21
20
19
18
17
16
15
14
13
12 11
10
4 5
6
3
22. Spring
23. Socket head screw (3 used)
24. Shift guide plate
25. Gasket (2 used)
26. Roll pin
27. Set screw (2 used)
28. Brake caliper
29. Brake disc
30. Cap screws (4 used)
31. Nut (4 used)
Greens Aerator
v
9
8
7