Magnamed OxyMag Operation Manual page 77

Problem
CO out of range alarm 1. Capnograph reading is incorrect.
2
1. Operating ambient pressure is out of range
alarm
IRMA out of range
2. The internal operating temperature is out of range.
IRMA zero required
1. Capnograph has lost calibration
alarm
Hight Temperature
1. The ambient temperature is above 50 ° C.
alarm
Low Temperature alarm 1. The ambient temperature is below -18 ° C.
1. The SpO2 sensor is connected to the equipment but
SpO Sensor alarm
is off the finger.
2
1. The oximeter has no sensor attached;
2. The connected sensor is defective;
Check SpO alarm 3. Interference detected;
2
4. Too much of ambient light;
5. Unknown sensor.
Check cable alarm 1. The oximeter cable is disconnected.
Low Perfusion alarm 1. The monitored perfusion is below the set alarm limit.
Looking for pulse alarm 1. The oximeter is looking for pulse
Activating SpO alarm 1. The oximeter being activated.
2
SpO demo alarm 1. The oximeter is generating a demonstrative curve.
2
77
Possible Causes Solutions
2. Locate the leak and correct.
1. Calibrate or replace the capnograph.
1. Operate the capnograph under
environmental conditions stated in the technical
specification.
2. Replace capnography sensor.
1. Calibrate the capnograph.
1. Operate the ventilator under environmental
conditions stated in the technical specification.
1. Operate the ventilator under environmental
conditions stated in the technical specification.
1. Connect the oximeter to the patient's finger.
1. Connect an oximetry sensor.
2. Replace the oximetry sensor.
3. Use the oximeter in an environment without
interference.
4. Decrease the ambient light.
5. Replace the oximetry sensor.
1. Connect the oximeter sensor cable.
1. Change the ventilation parameters or set the
lower limit of the Perfusion alarm.
1. Wait for the oximeter to find the patient's
pulse.
1. Wait for the oximeter to activate.
1. Disconnect and reconnect the oximetry
sensor or replace the sensor.
OxyMag_rev26