(C) IDM ENERGIESYSTEME GMBH
LAN connection
Plug for switching
valve
B48
B2
B41
B33
LAN connection
Hot water sensor B41
bottom area
Heat pump fl ow sensor
B33
Installation instructions iPump A 2-7, 3-11
The electrical lines between the electrical pan and the
hot water tank must be disconnected.
The sensors B41 and B48 are mounted in the immer-
sion sleeve with a clip.
The sensor B33 is located under the Armafl ex insula-
tion. The sensor must be pulled out carrfully.
Also the connection cable to the fl ow rate transmitter
B2 and the LAN connection for myiDM must be dis-
connected.
The plug for the switching valve must be disconnec-
ted.
After the transport and the assembly of the
heat pump all connections must be resto-
red. All described sensors above must be
installed in the immersion sleeves.
disassemble the ipump
Hot water sensor B48
Flow rate transmitter B2
Plug for switching valve
31