Disassamble The Ipump - iDM iPUMP A 2-7 Installation Instructions Manual

5. Disassamble the iPump

disassemble the ipump
The indoor unit of iPump A 2-7 and 3-11 can be disas-
sembled for the transport to the boiler room.
Open with a screw driver
Loos the fi xing screws
28
To remove the front panel, the interlocking device
must be opened with a screw driver or a pointed
object. The interlocking device is behind the white
cover, around 1 cm above the edge of the unit.
By pressing the locking bolt, the lock of the front panel
will be released.
The front panel can be unhinged out by gently lift up.
Please observe that the front panel is only handled on
the right and left side as shown in the photo.
It is not allowed to lift the front panel at the design
edge of the panel, otherwise the Front panel could be
damaged.
After the front panel is removed, the fi xing screws of
the side parts will be loosed.
The fi xing screws are located on the front as shown in
the photo on the left side.
The side parts and the rear panel are fi xed by additi-
onal connection pins. To loos the connection pins out
of the holder, the side parts have to be pulled gently
at the bottom. Afterwards, the connection between
the side part and the rear panel is loosened and the
side parts can be unhinged and removed.
Connection pins
Installation instructions iPump A 2-7, 3-11
5. Disassamble the iPump
Before the front part is removed for main-
tenance or repair work, please be sure
that the device is tensionless.
(C) IDM ENERGIESYSTEME GMBH