Table of Contents
Advertisement
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate the
appliance.
You cannot activate the
appliance.
Residual heat indicator
does not come on.
You cannot activate the
outer ring.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
The display shows "12.00". There was a power cut.
The display shows F11.
Steam and condensation
settle on the food and in
the cavity of the oven.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
Possible cause
The appliance is not con‐
nected to an electrical sup‐
ply or it is connected incor‐
rectly.
The fuse is released.
The zone is not hot be‐
cause it operated only for a
short time.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The lamp is defective.
The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
You left the dish in the
oven for too long.
The necessary data for the service
centre is on the rating plate. The rating
plate is on the front frame of the
appliance cavity. Do not remove the
rating plate from the appliance cavity.
ENGLISH
Remedy
Check if the appliance is
correctly connected to the
electrical supply.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse releases
again and again, contact a
qualified electrician.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Activate the inner ring first.
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Replace the lamp.
Reset the clock.
Put the plug of the core
temperature sensor as far
as possible into the socket.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
25
Advertisement
Table of Contents
