Install Guide Element; General Installation Information - Siemens SIWAREX WL230 Equipment Manual

Installation

5.3 Install guide element

1. Check the following items after the installation:
– The load bearing implement swings freely.
– The countersunk head screws
– The countersunk head screws
5.3 Install guide element
5.3.1

General installation information

Observe the information on installation of the compact installation units (see General
installation information (Page 27) ff.). The guide elements are prepared for flanging onto the
compact installation units. The length of the turnbuckle is set to the distance between the
flanges.
You can flange one or two guide elements.
With one guide element:
• You can flange a guide element on the front or rear of the compact installation unit. The rear
is recommended since the load cell is then always accessible.
• You can flange the guide element before or after installation of the compact installation unit
into the scale.
• You can flange the guide element before or after lowering of the load bearing implement.
Connection is recommended prior to lowering of the top plate since the compact installation
unit is still optimally aligned.
With two guide elements:
• Carry out installation of the first guide element as described above.
• Lower the load bearing implement.
• Install the second guide element.
34
The top plate has ideal freedom of movement and it prevents any incidental forces from
occurring.
①
Countersunk head screws Compact mounting unit (Page 13)
②
Top plate
Figure 5-6 Lifting protection and pendulum limitation
①
are located in the center in the bores of the top plate
①
must not project out through the top plate
Equipment Manual, 12/2020, A5E02390707B-03
②
.
②
.
SB-S SA