Advertisement
4. Set up Instruction
On/Off
Power on
Turn on
Turn Off (Restore to Original Setting)
Power off
Note:
Network Joining
Never Join the Network
Had Joined the Network
(Not restore to the original setting)
Fail to Join the Network
Function Key
Press and Hold for 5 Seconds
Press once
Insert 2 x 3V CR2450 button batteries into the battery slot in the correct direction and
close the back cover. (user may need a screwdriver to open)
Note: Require 2 button batteries to supply power at the same time.
Press any one of the function key and the green and red indicator flashes once.
Press simultaneously and hold two buttons for 5 seconds, and then the green indicator
flashes 20 times and the device will turn off automatically.
Remove Batteries
1. Remove and reinsert the battery: the device will remember the previous on/off status
by default.
2. If insert batteries and press the button at the same time, the device will be in
engineering testing mode.
3. On/off interval is suggested to be about 10 seconds to avoid the interference of
capacitor inductance and other energy storage components.
Turn on the device to search the network to join.
The green indicator stays on for 5 seconds: success
The green indicator remains off: fail
Turn on the device to search the previous network to join.
The green indicator stays on for 5 seconds: success
The green indicator remains off: fail
Suggest to check the device verification information on the gateway or consult your
platform server provider
Restore to the original setting / Turn off
The green indicator flashes 20 times: success
The green indicator remains off: fail
The device is in the network: the green indicator flashes once and sends a report
The device is not in the network: the green indicator remains off
4
Advertisement
