ABB ACS2000 AFE 2MVA User Manual page 97

97 ACS2000 AFE 2MVA UM 3BHS355653 ZAB E01 REV. H
—
6.9 Power cables, ground cables,
equipotential bonding conductor
The method to prepare the cables for connection to their
corresponding busbars is described below.
6.9.1 Further information
• Project-specific cable entry
• Distance between the point of cable entry and
the termination bars
• Busbar and fastening hole dimensions
• Busbar designations
See the applicable Wiring diagrams
on:
• Conventions for cross-references and device
identification
6.9.2 Preparing the cable entry and the cables
NOTICE
Risk of damage or malfunction!
Waste inside the cabinet can cause damage or
malfunction.
If possible, do not cut cables inside the terminal
compartment. Retrieve any waste which
accidentally dropped into the cabinet.
Determining the cable length
1. Determine the required length of a cable
between the point of entry and the connection
point inside the cabinet.
2. Cut the cable to the required length before con-
nection.
See the applicable Mechanical drawings
for information on:
for information