ABB ACS2000 AFE 2MVA User Manual page 144

CHAPTER 9 – CDP CONTROL PANEL
—
9.6 Parameter mode
Running a drive with the correct settings is essential for the proper
operation, efficiency and safety of the system.
NOTICE
Running the drive system with incorrect data can
result in improper operation, reduction of control
accuracy and damage of equipment. Do not
change any parameter, if the meaning of the
parameter and the effects of the change are not
fully understood.
Group 07
Group 08
Group 09
Group 11
Group 12
Group 16
Group 17
Group 18
Group 19
Group 20
Group 21
Group 22
Group 23
When the parameter mode is entered for the first
time after the auxiliary voltage of the drive has
been switched on, the display will show the first
parameter of parameter group 11. The next time
the parameter mode is entered, the previously
selected parameter is shown.
Some parameter values cannot be changed while
the drive is running. If tried, the following warning
will be displayed:
**
Control words
Status words
Fault & alarm words
Start / stop / direction / MCB control
Reference selection
System control inputs
DC link control
Utility
Data storage
Limits
Start / stop / process stop
Ramp functions
Speed reference
For further information on the parame-
ters, their settings and functions, see
nal and parameter table
WARNING
**
WRITE ACCESS DENIED
PARAMETER SETTING
NOT POSSIBLE
Parameters allow the drive to be configured and
set-up specifically for an application. Parameters
are organized in functional groups. All control func-
tions are represented by a parameter group and
can be activated and set-up individually by the
parameter mode.
21.01
21.02
21.03
21.04
21.05
21.06
21.07
.
.
.
21.17
21.17
21.19
Sig-
.
Start function
Start function
Off1 stop mode
Process stop selection
Process stop signal
Process stop MCB control
Process stop mode
t
MCB closing time limi
MCB available signal
144