ABB ACS2000 AFE 2MVA User Manual page 141

141 ACS2000 AFE 2MVA UM 3BHS355653 ZAB E01 REV. H
—
9.5 Actual signals mode
Two displays can be selected in the actual signals mode:
9.5.1 Overview
Two kinds of displays can be selected in the actual
signals mode:
• Actual signals display
• Fault history display
The actual signals display appears first when the
actual signals display mode has been selected.
However, when the drive is in a fault condition, the
fault display will be shown instead.
The actual signals display is used to monitor the
drive without interfering its operation. Three
selectable actual values are shown continuously on
the display.
The CDP control panel will automatically return to
the actual signals mode from other modes within
one minute when no keys are pressed (exceptions:
status display and common reference display when
in drive selection and fault display mode).
Actual values
Group 01
Group 02
Group 03
Group 04
Group 05
Group 06
Group 07
Group 08
Group 09
Fault memory
The fault memory includes information on the 64
most recent fault events that occurred in the drive.
The name of the fault and the actual time are dis-
played. The procedure for selecting and clearing
the fault history is described in section
playing and resetting an active
When a fault or warning is generated in the drive,
the message will be displayed immediately, except
when in drive selection mode.
Changing from the fault display mode to other dis-
play modes is possible without resetting the fault
first. When no keys are pressed, the fault or warn-
Measured or calculated motor values
Measured or calculated drive values
Reference values
I/O status signals
Communication link and MCB status signals
Software version, drive and motor nominal
values
Control words
Status words
Fault and alarm words
For the complete list of selectable actual
signals, see Signal and parameter table
fault.
ing text is displayed as long as the fault is pending.
Control panel overview
1 L ->
StateINU
MOTOR SP
POWER
3
4
Status line
1
Actual signal names and values
2
Selects the function mode
3
Selects actual signals and faults
4
Scrolls through signal and fault messages
5
Enters the selection mode
6
Acknowledges the selection
9.5.2 Selecting the actual signals display
To open the actual signals display, press the ACT
key.
9.5.7 Dis-
1
600.0 rpm
ReadyOn
2
0.00 rpm
0.0 kW
6
5
600.0 rpm
1 L ->
ReadyOn
StateINU
MOTOR SP 0.00 rpm
POWER
0.0 kW