Printing - Welch Allyn PneumoCheck Operating Instructions Manual

PRINTING

1.
Place the PneumoCheck in the Printer/Charger well with the
display facing you. When the instrument is properly seated,
the orange charging indicator on the PneumoCheck will become
illuminated.
LIQUID CRYSTAL
DISPLAY
DATA -
INDICATOR
(GREEN)
POWER -
INDICATOR
(ORANGE)
2. The green DATA indicator on the Printer/Charger will flash
during data transfer and the PneumoCheck Liquid Crystal
Display will display SEND FVC and/or SEND MVV or SEND
CAL. When data transfer is complete, the green DATA indicator
will stop flashing and a triple tone beep will occur.
NOTE: Instrument may be removed after data transfer; data will
remain in printer memory until new data is entered or power is
disconnected.
3. Press the PRINT button momentarily to begin printing. A full
FVC report takes approximately 20 seconds to print.
4. Tear the report off by pulling the paper towards you.
5. For a duplicate report, press the PRINT button again.
27
CHARGING
INDICATOR
(ORANGE)