Starting The Projector With A Password; Disabling The Projector's Buttons; Presenting Over A Wireless Network - Epson PowerLite 737c Product Information

Epson PowerLite 737c Projector

Starting the Projector with a Password

Note:
You must unplug the projector and then plug it back in to enable
password protection.
When the password function is enabled, you see this screen
when you plug in and turn on the projector:
Hold down the button on the remote control as you use
Num
the numeric keypad buttons to enter the password. Once you
have entered the password correctly, the password screen closes,
and projection begins.
If the password is not correct, you see the message
password. Please try again
password three times in succession, you see the message
projector's operation will be locked. Request code xxxxx
and the projector switches to standby mode for approximately 5
minutes. Write down the request code. Then disconnect the
projector's power cord from the electrical outlet, reconnect it,
and turn the projector back on. When you see the Password
Protect Release screen, enter the correct password.
If you have forgotten the password, contact Epson for assistance
and give them the request code number that appears in the
Password Protect Release screen.
If you enter an incorrect password 30 times in a row, the
projector remains locked and you must contact an authorized
Epson servicer to unlock it.
10 Epson PowerLite 737c Projector
-
Wrong
. If you enter an incorrect
The

Disabling the Projector's Buttons

When you enable the Operation Lock function, all the
projector's buttons are disabled except the P
This is useful, for example, if you want to prevent students in a
classroom from playing with the projector.
1. Press the button.
Menu
2. Select the
Setting
3. Select
Operation Lock
4. Select and press
ON
to confirm the setting.
5. Press the button to exit the menu system.
Menu
Note:
You can cancel Operation Lock by pressing the projector's
button for 7 seconds.

Presenting Over a Wireless Network

Using EMP NS Connection, you can project images shown
on your computer screen directly to your audience without
connecting the projector to your computer. Before you begin,
make sure you've installed EMP NS Connection from the
CD-ROM that came with your projector. See the User's Guide
for installation instructions.
Starting EasyMP
Before you can connect to the projector wirelessly, you have to
switch it to EasyMP mode.
1. Turn on the remote control and the projector. Press the
button on the remote control to select EasyMP as
EasyMP
the source.
2. Locate the Epson 802.11 b/g card that came with your
projector. Insert it with the label facing upward.
Note:
Only the Epson 802.11 b/g card is guaranteed to work.
Other cards may not be compatible. Replacement cards are
available only through an Epson authorized servicer.
2/05
Power
menu and press .
Enter
and press .
Enter
. Then select and press
Enter Yes
™
button.
Enter
Enter