Advertisement
OPTIONAL COUNTER COMMANDER (SF-EA13)
START/
STOP
P
S
V
24
Downloaded from:
http://www.usersmanualguide.com/
1
2
PPC
C
P P
Mode switch
3
Connector cover
<P011>
Arrow to
the top
<P013>
FEED
Q
R
T
U
W
X
4
O
b
5
6
I
I
For Printing Data through Key Operator
Programs
For printing data through the key operator programs, Counter Com-
mander SF-EA13 must be connected to the copier.
If optional Card Counter SF-EA11 is installed, refer to corresponding
manual for printing data through SF-EA11.
Set the mode switch at the right side of counter
commander to [PPC].
Open the right front door of the copier, lift the
connector cover, and connect the counter commander
cable to the copier with the arrow on the connector
facing UP.
Enter a key operator program from which printed data
is required, and select print.
The following message will appear in the message display of
the copier.
PUSH THE START/STOP KEY ON THE SF-EA13.
If the counter commander is not connected or if the mode
switch of the counter commander is not properly set, the fol-
lowing message will appear.
COUNTER COMMANDER ERROR.
CHECK CONNECTION AND ENSURE MODE
SWITCH IS IN THE PPC POSITION. THEN
RE-ENTER P CODE.
Connect the counter commander properly, press the CLEAR
ALL key and then enter the program code again.
Press the START/STOP key of the counter commander.
The counter commander will start to print.
Printing can be stopped or started as desired by pressing the
START/STOP key.
Continue steps 3 and 4 for printing data for other
programs.
When printing of key operator programs has been
completed, remove the counter commander cable from
the copier, close the connector cover and close the
copier.
Advertisement
