Advertisement
KEY OPERATOR PROGRAMS
P19 Key Operator Code Number Change
See page 2, KEY OPERATOR CODE NUMBER.
P20 Auto Exposure Adjust
Use P20 to lighten or darken copies in the automatic exposure
mode. The factory setting is "NORMAL."
When P20 is entered, the following message will appear.
P21 Power Up Timer
The power up timer will automatically turn off the power to the copier
after a length of time has elapsed from the time the copier was
turned on. Use P21 to select the mode and to set the time interval.
The interval can be set for up to 24 hours in 10 minute increments.
When P21 is entered, the following message will appear.
P22 Toner Save Mode
The toner save mode will reduce toner consumption by approxi-
mately 10% in the automatic and manual exposure modes. Copies
will be lighter but still adequate for general use. When this mode is
selected, the photo mode is not affected.
When P22 is entered, the following message will appear.
14
Downloaded from:
http://www.usersmanualguide.com/
I
I
<G038>
P20: AUTO EXPOSURE ADJUST.
1.LIGHTEST
4.DARKER
Select the desired exposure level using the 10-key pad.
<P076>
P21: POWER UP TIMER.
SET THE TIME INTERVAL FOR POWER UP
0:00 AND PRESS START.
TO CANCEL PRESS C KEY AND THEN
THE START KEY.
To set an interval
1.
Enter the time interval using the 10-key pad.
2.
Press the START key.
To cancel the power up timer
1.
Press the CLEAR/STOP key.
2.
Press the START key.
<P040>
P22: TONER SAVE MODE
1.YES
Select either yes or no using the 10-key pad.
2.LIGHTER
3.NORMAL
5.DARKEST
2.NO
Advertisement
