Pit Boss 820FB Owner's Manual page 8

Section One:
ASSEMBLING & MOUNTING THE CART
Step 2 Install Bottom Shelf Assembly:
Models 820FB—Open Shelf

Install the Bottom Shelf to all four legs.
Using 4 of the 1/4" x #20 x 3/5" screws (AA) and your
Screw driver, hand start then secure the screws firmly to
the leg frame.
Note: Ensure the shelf is installed so the flat surface is facing up

NOW, securely tighten ALL 16 leg screws (AA)
Step 3 Install Wheels to Leg Assembly:

Slide metal wheel onto either leg with the
axle

Install washer (CC), then hand screw the
7/16" x 20 Nut (BB) onto the threaded
axle. Use your wrench to tighten.

Spin each wheel to ensure the wheels
turn freely.

Carefully lift barrel and attached leg
assembly to the upright position.
Parts Needed:
Hardware Required:
Screw 1/4"- 20* 3/5" x 1 (AA)
Installation Steps
Step 1 Attach Lid Stopper

Slip the Lid Stopper front lip into the slot provided
Located at the top of the barrel in the middle.

Using the screw driver, secure the Lid Stopper
to the barrel with one 1/4" - #20 x 3/5" (AA) screw.
Take care not to over-tighten.
ASSEMBLY INSTRUCTIONS
Model 820Deluxe—Solid Shelf
ASSEMBLING—LID STOPPER
...
CON'T
Page 8