Starting The Projector With A Password - Epson PowerLite 400W User Manual

Starting the Projector with a Password

When the password function is enabled, you see this screen when you
turn on the projector:
Use the numeric buttons on the remote control to enter the password.
Once you have entered the password correctly, the password screen
closes, and projection begins.
If the password is not correct, you see the message
Wrong password.
If you enter an incorrect password three times in
Please try again.
succession, you see the message
The projector's operation will be
and the projector switches to standby
locked. Request code xxxxx
mode for approximately 5 minutes. Write down the request code.
Then disconnect the projector's power cord from the electrical outlet,
reconnect it, and turn the projector back on.
When you see the Password Protect Release screen again, you can try
to enter the correct password.
If you enter an incorrect password 30 times in succession, the
projector remains locked and you must contact Epson for service.
If you have forgotten the password, contact Epson with the request
code number that appears in the Password Protect Release screen for
assistance. See "Where To Get Help" on page 91.
Fine-tuning the Projector
70