• Kasco WaterGlow lighting kits are intended for use with a Listed control panel having a GFCI protected receptacle, or field wiring terminals and disconnect switch, or a timer with a disconnect for use with a GFCI receptacle. They are intended to be mounted on a floating fountain or aerator for use in a natural or man-made body of water to comply with NEC Article 682.
Back to Contents MOUNTING INSTRUCTIONS 1. Attach the bracket (H) to the light fixture (C) by fitting the head of the 10-32 x 1/2’’ hex screw (I) into the tabs on each side of the fixture. Place one bracket O-ring (G), one #10 lock washer (F), and one thumb nut (E) on each #10 screw outside the bracket.
Page 6
Back to Contents MOUNTING INSTRUCTIONS (CONT.) 3. (Optional) Place lens caps over the light fixture (C) as shown. Ensure the cap is seated all the way down onto the fixture housing, as shown. Make sure the fixture and lens are clean before installing the lens cap.
Page 7
Back to Contents MOUNTING INSTRUCTIONS (CONT.) 5. After attaching the unit to the float according to fountain/aerator instructions, push the clips into recess- es on float until you hear an audible click indicating the fixture is secure. Ensure clip is fully seated on float 6.
Supplementary hardware is required in order to mount RGBC5 light fixtures to a large (2HP+) surface aera- tor. Use the additional hardware kit (P/N 840303 for 3 light fixtures or 840306 for 6 light fixtures). These kits are sold separately. Contact Kasco at sales@kascomarine.com or your local distributor for order information.
The following maintenance procedures can be utilized to ensure many years of quality performance from your Kasco fountain and light kit and reduce the need for more costly repair work. Note that the LED fixtures are sealed and do not require any maintenance other than cleaning. Do not attempt to open light fixtures, as this will void the warranty.
Page 10
Back to Contents TROUBLESHOOTING TIPS (CONT.) • C-25 control panel: The C-25 timer must be turned on (fountain operating) to allow the light circuit to energize. • C-85, or C-95 control panel with GFCI outlet and photo eye control: The fountain timer must be turned on (fountain operating) to allow the light circuit to energize.
Warranty period: LED3C11, LED6C11 = 3 year Limited Warranty. Kasco® Marine, Inc. warrants this light kit to be free from defects in material or workmanship under normal use and service. The Kasco Marine, Inc. obligation under this warranty is limited to replacing or repairing free of charge any defective part within the warranty period from the date of shipment.
Most failed equipment can be repaired at substantially lower costs than replacement with new. If your light kit requires repair and is no longer covered under warranty, please contact Kasco or your local distributor for available options. Please ship according to the instructions above.
Back to Contents REPAIR CONTACT FORM • Kasco requires that all equipment sent for repair MUST be accompanied by this form and marked to Repairs attention. Kasco Marine • Unit should be cleaned before shipping. 800 Deere Road • Kasco is NOT responsible for shipping damage accrued in Prescott, WI 54021 return shipment.