10-11 Replacement Parts pg 12 Important Safety: Please read and follow these important instructions to help ensure your safety and the quality performance of your Kasco equipment. • Caution should be used when dealing with any electrical and/or moving equipment.
Mounting Instructions Step 1 Attach the bracket (F) to the light fixture (A) by fitting the head of the 10-32 x 1/2’’ hex screw (G) into the tabs on each side of the fixture. Place one bracket O-ring (E), one #10 lock washer (D), and one thumb nut (C) on each #10 screw outside the bracket.
Page 5
Step 3 After attaching unit to the float according to fountain/aerator instructions, push clips into recesses on float until an audible click is heard and fixture is secure. Ensure clip is fully seated on float Step 4 Repeat for remaining fixtures, spacing evenly around the float. Adjust angle of lights using thumb nuts if desired, being sure that the same angle is used for all fixtures.
Page 6
For 3400/4400 JF/VFX/AF units: For 8400 JF/VFX/AF and larger units: Included with the RGB3C5 Kit is optional hardware for use Included with the RGB3C5 Kit is required hardware for use instead of the snap-on light clip. Assemble parts I, J, K, and L instead of the snap-on light clip.
Step 6 The RGB control box is ready to mount next to your Kasco fountain control box (mount a minimum of 5ft from water) using two exterior-grade wood screws; one for the top and one for the bottom hanger. Tighten the top screw to prevent the box from lifting off the screws.
Warranty Policy Warranty period: RGB3C5, RGB6C5 = 2 year Limited Warranty: Kasco® Marine, Inc. warrants this Light Kit to be free from defects in material or workmanship under normal use and service. The Kasco Marine, Inc. obligation under this warranty is limited to replacing or repairing free of charge any defective part within the warranty period from the date of shipment.
This includes tampering with the unit, power cord, and/or control box. A physical Kasco Repair Form must be included with any equipment sent to Kasco or an Authorized Repair Center. This form can be found under the Product Support section of kascomarine.com. If no Repair Form is available, include your name and physical address for return delivery of the repaired Light Kit and a daytime phone number and/or e-mail address for correspondence regarding the warranty claim.
Troubleshooting Tips The following is provided to help diagnose a probable source of trouble. It is a guideline only and may not show all causes for all problems. For additional troubleshooting help, contact your local distributor or visit kascomarine.com for additional guidance. Note: you may need to refer to your owners manual that was provided with your fountain for additional control panel settings and adjustments.
Page 11
or an internal wiring issue with the panel. If the module resets, then reconnect the fountain then the light kit to see which one trips the module. “My lights work, but they are not as bright as they were when fist installed.” Dirty lenses may be to blame.
Page 13
Sales@kascomarine.com Repair Contact Form ❖ Kasco requires all Repairs sent in MUST be accompanied by this form and marked to Repairs attention. (ex. Attn: Repairs) ❖ Repairs returned should include upper pump housing or wire basket for Aerators and De‐Icers. These parts protect the motor during shipping.
Need help?
Do you have a question about the RGB3C5 and is the answer not in the manual?
Questions and answers