• Kasco WaterGlow lighting kits are intended for use with a Listed control panel having a GFCI protected receptacle, or field wiring terminals and disconnect switch, or a timer with a disconnect for use with a GFCI receptacle. They are intended to be mounted on a floating fountain or aerator for use in a natural or man-made body of water to comply with NEC Article 682.
Back to Contents LED3S19, LED6S19 WATERGLOW STAINLESS STEEL LIGHTING MANUAL MOUNTING INSTRUCTIONS MOUNTING INSTRUCTIONS 1� Attach the S19 bracket (F) to the light fixture (C) by using two 1/4”-20 x 1/2”’ hex screws (D) on either side in combination with 14” lock washers (E).
Page 5
Back to Contents LED3S19, LED6S19 WATERGLOW STAINLESS STEEL LIGHTING MANUAL 3. (Optional) Place lens caps over the light fixture (C) as shown. Ensure the cap is seated all the way down onto the fixture housing. Make sure the fixture and lens are clean before installing the lens cap. Repeat for all fixtures. Fig.
Page 6
Back to Contents LED3S19, LED6S19 WATERGLOW STAINLESS STEEL LIGHTING MANUAL 5� After attaching the unit to the float according to fountain/aerator instructions, push the clips into recesses on float until you hear an audible click indicating the fixture is secure. Fig.
Warranty period: LED3S19, LED6S19 = 3 year Limited Warranty: The following maintenance procedures can be utilized to ensure Kasco® Marine, Inc. warrants this Light Kit to be free from de- many years of quality performance from your Kasco fountain and fects in material or workmanship under normal use and service.
A physical Kasco Repair Form must be included with any equip- ment sent to Kasco or an Authorized Repair Center. This form Once warranty coverage has been established, the equipment may be sent to any Kasco Authorized Repair Center or to Kasco can be found under the Product Support section of kascomarine�...
• Kasco C-25, C-85, and C-95 control panels have a photo eye on the left side of the enclosure exterior. This photo eye measures ambient light. To activate, the photo eye must not measure any ambient light for at least several minutes. Covering the photo eye with black electrical tape will activate the photo eye for testing.
Page 10
Back to Contents LED3S19, LED6S19 WATERGLOW STAINLESS STEEL LIGHTING MANUAL 884050 / 2021.1.2...
LED3S19, LED6S19 WATERGLOW STAINLESS STEEL LIGHTING MANUAL REPAIR CONTACT FORM • Kasco requires that all equipment sent for repair MUST be accompanied by this form and marked to Repairs attention� • Kasco is NOT responsible for shipping damage accrued in return shipment� •...