• Kasco WaterGlow lighting kits are intended for use with a Listed control panel having a GFCI protected receptacle, or field wiring terminals and disconnect switch, or a timer with a disconnect for use with a GFCI receptacle. They are intended to be mounted on a floating fountain or aerator for use in a natural or man-made body of water to comply with NEC Article 682.
(B) of your choice. Place the lens inside the lens cap (A) making sure the 3 flaps are holding the lens in place. Repeat this step for all lens caps. Continue to Step 3. No gap Flaps behind lens LED4C11 MANUAL...
Page 6
Make sure the fixture and lens are clean before installing the lens cap. Repeat for all fixtures. 4. Assemble parts J, K, L, and M as shown to secure the fixture to the float and tighten until secure. • 7/16’’ socket and wrench required. LED4C11 MANUAL...
Page 7
Cable-tie the light kit power cord to the float opposite the fountain power cord for balance and to prevent damage from the fountain. Remem- ber: LEDC11 fixtures MUST be properly submerged (approximately halfway) to avoid overheating. LED4C11 MANUAL...
The following maintenance procedures can be utilized to ensure many years of quality performance from your Kasco fountain and light kit and reduce the need for more costly repair work. Note that the LED fixtures are sealed and do not require any maintenance other than cleaning. Do not attempt to open light fixtures, as this will void the warranty.
Page 9
Over time, algae growth and hard water depos- its on the lenses can block light output. Clean the lenses with a soft brush and the light should be bright again. LED4C11 MANUAL...
WARRANTY Warranty Policy Warranty period: LED4C11 = 2 year Limited Warranty. Kasco® Marine, Inc. warrants this light kit to be free from defects in material or workmanship under normal use and service. The Kasco Marine, Inc. obligation under this warranty is limited to replacing or repairing free of charge any defective part within the warranty period from the date of shipment.
Most failed equipment can be repaired at substantially lower costs than replacement with new. If your light kit requires repair and is no longer covered under warranty, please contact Kasco or your local distributor for available options. Please ship according to the instructions above.
Back to Contents REPAIR CONTACT FORM • Kasco requires that all equipment sent for repair MUST be accompanied by this form and marked to Repairs attention. Kasco Marine • Unit should be cleaned before shipping. 800 Deere Road • Kasco is NOT responsible for shipping damage accrued in Prescott, WI 54021 return shipment.
Need help?
Do you have a question about the LED4C11 and is the answer not in the manual?
Questions and answers