Servicing Specific Components; Cleaning The Thread Clamp - DURKOPP ADLER D868 Service Instructions Manual

18.4 Servicing specific components

18.4.1 Cleaning the thread clamp

Cleaning the thread clamp
Fig. 134: Cleaning the thread clamp (1)
(1) - Spring
(2) - Screw
To clean the thread clamp:
1. Loosen the screw (2).
2. Disassemble the thread clamp (3).
Important
Make sure not to lose the spring (1).
3. Blow out the magnet (4) using a compressed air gun.
4. Check the thread clamp (3) for sharp edges.
If the thread clamp (3) has sharp edges:
5. Polish or change the thread clamp (3).
6. Assemble and align the thread clamp ( p. 193).
192
① ②
③
(3) - Thread clamp
(4) - Magnet
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020
Maintenance
④