Table of Contents
Advertisement
17.8.7 Network
The Dynamic Host Configuration Protocol (DHCP) makes it possible to
assign the network configuration to the server.
You need to set up the network if you wish to connect the machine to
the QONDAC.
To set up the network:
1. Activate DHCP.
The drop-down menu is enabled.
2. Enter the following information in the drop-down menu:
17.8.8 Logging
Logging is used to store all messages relating to the activities of the
machine.
Fig. 126: Logging
(1) - Control panel
(2) - Levels
(3) - Data
178
• IP-Address for QONDAC
• Subnet Mask for QONDAC
• Gateway for QONDAC
• Nameserver
①
②
③
④ ⑤
(4) - Export
(5) - Reset
(6) - Magnifier
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020
Programming
⑥
Advertisement
Table of Contents
