Aligning The Feed Dog In Sewing Direction - DURKOPP ADLER D868 Service Instructions Manual

Adjusting feed dog and needle bar linkage

7.4 Aligning the feed dog in sewing direction

Order
Start by aligning the needle bar linkage in the sewing direction ( p. 50).
Fig. 39: Aligning the feed dog in sewing direction
(1) - Screw
To align the feed dog in the sewing direction:
1. Execute the service routine Feed dog > Position to
 The software is used to define the necessary presettings on the
2. Open the hook cover ( p. 28).
3. Tilt the machine head ( p. 18).
4. Loosen the screw (1).
5. Align the feed dog in the sewing direction such that the needle pierces
6. Tighten the screw (1).
Order
Next, check the feed movement to the throat plate cutout at the maximum
stitch length.
Service Instructions D868 M-TYPE DELTA - 00.0 - 06/2020
①
needle ( p. 14).
machine.
in the center of the needle hole.
51