Coleman HS400UTV-2 Owner's Manual page 31

5. Tachometer
6. Odometer/Trip meter A / Trip meter B/Clock/Hour button
7. Metric/mile button
8. Speedometer
Speedometer unit functions:
 a speedometer (which shows the speed)
 an odometer (which shows the total
distance covered)
 a trip meter (which can be cleared and
then show any new distances traveled)
 an RPM indicator (which shows the
revolutions per minute of the engine)
 a clock
 an EFI fault code indicator (which shows
the fault code for problems with the EFI )
Odometer and trip meter modes
Control Functions
On the display panel there are two large
buttons, one located on the left side and one
on the right side.
button on the left side toggles the display
from the odometer, to the trip meter, and the
to the hours meter; then it starts the cycle
over.
The odometer displays the total distance
traveled by the UTV. The trip meter records
distances for a specific trip and can record
distances from 0 through 999.9 miles.
To reset a trip meter, hold down the right
button for an extended period of time until the
trip meter resets. The trip meter can be used
to estimate the distance that can be traveled
with a full tank of fuel. This information will
enable you to judge the fuel consumption.
4-6
Quickly pressing the