Coleman HS400UTV-2 Owner's Manual page 156

8-52 Periodic Maintenance and Adjustment
fasteners and bolts, and then tighten the
bolts to the specified torque.
Tightening torque:
Panel bolt:
6.5N·m (0.65 m·kgf，4.7 ft·lbs)
Troubleshooting
Although vehicles receive a rigid inspection
before shipment from the factory, trouble
may occur during operation. Any problem in
the fuel, compression, or ignition systems
can cause poor starting and loss of power.
The troubleshooting chart describes a quick,
easy procedure for making checks. If your
vehicle requires any repair, take it to a
service center.
The skilled technicians at a service center
have the tools, experience, and know how to
properly service your vehicle. Imitation parts
may look like original parts, but they are often
inferior. Consequently, they have a shorter
service life and can lead to expensive
WARNING
POTENTIAL HAZARD
Checking the fuel system while smoking
or near an open flame.
WHAT CAN HAPPEN
Fuel can ignite or explode, causing
severe injury or property damage.
HOW TO AVOID THE HAZARD
Do not smoke when checking the fuel
system. Make sure there are on open
flames or sparks in the area, including
pilot lights from water heaters of
furnaces.