Figure 7.11 Motor End Cover; Figure 7.12 Equalizing Tube And Lock Screw Assembly - Carrier 69NT40-541-001 Operation And Service

Container refrigeration units

Table of Contents

h. Be very careful not to damage the motor windings when removing the motor end cover (see

as the cover fits over the winding coils. Loosen the cap screws, break the seal and then remove all cap-

screws except one in the top of the cover. While holding the cover in place, remove the remaining capscrew.

Do not allow the cover to drop from its own weight. To prevent striking the winding, remove the cover hori-

zontally and in line with the motor axis.

1. Strainer Screws and Washers

2. Suction Strainer

3. Motor End Cover Gasket

4. Motor End Cover

Remove the refrigerant suction strainer. If it is removed with ease it may be cleaned with solvent and

replaced. If the strainer is broken, corroded or clogged with dirt that is not easily removed, replace the

strainer. Install new gaskets upon reassembly.

Block the compressor crankshaft so that it cannot turn. Use a screwdriver to bend back the tabs on the lock-

washer and remove the equalizer tube and lock screw assembly. (See

of the tube draw vapor from the crankcase. Remove the rotor using a jack bolt. Insert a brass plug into the

rotor hole to prevent damage to the end of the crankshaft.

k. If the piston rings extend beyond the cylinder tops, the pistons can be pulled through the bottom plate open-

ing after the piston rings are compressed. A piston ring compressor will facilitate removal. Each piston pin is

locked in place by lock rings which are snapped into grooves in the piston wall. (See

Since the stator cannot be replaced in the field, the terminal plate assembly need not be disturbed unless a

leak exists and the plate assembly needs to be re placed. If no terminal plate repair is required, proceed with

reassembly.

Figure 7.12 Equalizing Tube and Lock Screw Assembly