Graco ProBell 24Z221 Instructions And Parts page 15

One One Gun One Gun Wiring Gun Wiring Wiring
Note
For systems without an electrostatic controller (CC), connect the system logic controller directly to an
open CAN port on either the speed controller (EE) or electronic air controller (BB).
Two Gun Gun Wiring Wiring
Two Two Gun Wiring
Other configurations (not shown) are possible. Follow these rules when building the CAN network.
• Connect controllers in series.
• A termination resistor must be installed on the
power supply port.
3A3954D
• Remove any other termination resistors from the
system.
• Set IDs on all boxes.
Controller Connections
15