Maintenance; Plug Replacement (Uk & Ireland Only) - Worx WU645 Instruction Manual

medium grit for smooth surfaces and fine grit
for the final surfaces. If necessary, first make a
test on scrap material.
Use only good quality sandpaper.
The sanding efficiency is controlled by the
sandpaper not the amount of force you apply
to the tool. Excessive force will reduce the
sanding efficiency and cause motor overload.
Replacing the sanding paper regularly will
maintain optimum sanding efficiency.

MAINTENANCE

Your power tool requires no additional
lubrication or maintenance.There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep
all working control free of dust. If you see
sparks flashing in the ventilation slots, this is
normal and will not damage your power tool.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
PLUG REPLACEMENT (UK &
IRELAND ONLY)
If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue – Neutral
Brown – Live
As the colors of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals
in your plug, proceed as follows.The wire
which is coloured blue must be connected to
the terminal which is marked with N.The wire
which is coloured brown must be connected
to the terminal which is marked with L.
Warning: Never connect live or neutral wires
to the earth terminal of the plug. Only fit an
Palm Sander
13L-WU645-M-070305¸ÄFÓïCE´¦.indd 9
approved BS1363/A plug and the correct rated
fuse.
Note: If a moulded plug is fitted and has to be
removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip
09
ENG
3/5/2007 4:09:51 PM