Table of Contents
Advertisement
After covering a flat surface, polish curved surfaces
such as car doors and mudguards. Do not use a
polisher to press the surface down. Turn the polisher
off before you remove it from the surface. (See Fig.
E1)
NOTE: It is also convenient to use one hand to polish
the roof and car sides. (See Fig. E2)
NOTE:For hard to reach areas, such as the underside
of bumpers or side mirrors, apply polish by hand.
(See Fig. E3)
6. CHANGE TO BUFFING/POLISHING BONNET
TO THE FOAM PAD (SEE FIG. F)
Place the switch in the OFF (O) position. Remove the
battery pack from the tool. Place the wool bonnet on
foam pad.
7. BUFFING AND POLISHING - REMOVING THE
WAX FROM THE SURFACE (SEE FIG. G)
NOTE: Wait until wax has dried to an even haze on
vehicle. Remove wax in the same order in which it
was applied.
Turn the polisher to the ON position. Polish and buff
the entire surface until all dried wax is removed.
Remove the bonnet from time to time and shake out
the residue.
NOTE: For best results, use long, sweeping strokes
in a criss-cross pattern when removing wax.
WORKING TIPS FOR YOUR
10
POLISHER
1. Always let the polisher work and do not force it or
apply excessive pressure on the polisher. Preferably,
use a light circular motion.
2. If pad absorbs too much wax, it will not last long,
and polishing is more difficult and takes longer.
3. If bonnet continually comes off pad, please try
with a new bonnet.
4. If the wax seems difficult to polish, apply wax in a
thin, even coat.
TROUBLESHOOTING
1. If the polisher does not abrade surface, checking
the bonnet. If the bonnet has been worn, replace the
new bonnet and try again.
2. If a fault can not be rectified, return the tool to an
authorized dealer for repair.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
20V
Cordless Orbital Tool
of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not
damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0
The recommended ambient temperature range for
the charging system during charging is 0
(32°F-104°F).
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
C-45
C (32°F-113°F).
o
o
C-40
C
o
o
WX856
WX856.X
Advertisement
Table of Contents
