Important Safety Instructions - Epson Stylus Color 200 User Manual

Important Safety Instructions

Before using your printer, read the following safety
instructions to make sure you use the printer safely and
effectively.
Turn off and unplug the printer before cleaning. Clean with
a damp cloth only. Do not spill liquid on the printer.
Do not place the printer on an unstable surface or near a
radiator or heating vent.
Do not block or cover the openings in the printer's cabinet
or insert objects through the slots.
Use only the type of power source indicated on the
printer's label.
Connect all equipment to properly grounded power
outlets. Avoid using outlets on the same circuit as
photocopiers or air control systems that regularly switch
on and off.
Do not let the power cord become damaged or frayed.
If you use an extension cord with the printer, make sure
the total ampere rating of the devices plugged into the
extension cord does not exceed the cord's ampere rating.
Also, make sure the total of all devices plugged into the
wall outlet does not exceed 15 amperes.
Except as specifically explained in this User's Guide, do not
attempt to service the printer yourself.
Unplug the printer and refer servicing to qualified service
personnel under the following conditions:
If the power cord or plug is damaged; if liquid has entered
the printer; if the printer has been dropped or the cabinet
damaged; if the printer does not operate normally or
exhibits a distinct change in performance. Adjust only those
controls that are covered by the operating instructions.
9
Introduction