Draining - Mitsubishi Electric MJ-EZ6CX-S1-IT Instruction Manual

Draining

The unit automatically shuts down and lights the Tank full lamp when the tank is full.
Empty the water tank.
When the water tank becomes full, the "FULL lamp" lights.
1
Remove the water tank.
Grasp handle and
slide out.
If you remove the tank, the FULL lamp lights.
<Hold the tank this way>
Remove the tank lid, and pour
2
out the water.
Tank lid
Floating element
Do not remove this.
16
e̲mj̲ez6cx̲s1.indb 16 e̲mj̲ez6cx̲s1.indb 16
Lit
Tank full lamp lights.
(The unit beeps continuously).
Blowing stops (louvre stops).
The operation indicator lamp turns
off.
Pour the water out as shown.
After removing the water and
replacing the tank, the Tank full
lamp will go off, and the unit will
automatically return to operation
mode.
When the Tank full lamp is lit,
no operation but ON/OFF is
possible.
Slide the tank lid to close the
3
tank.
Check the tank lid, and
fi rmly push it all the way in.
Check the tank, and fi rmly
4
push it all the way in.
Tank lid
Press the edge to insert
it fi rmly into place.
Water tank
Make sure the tank
is not broken or
cracked
A beep is heard and the lamp turns off.
Not attaching the tank lid properly may result in water
leaking.
If the tank lid is not inserted fi rmly, it may not be
possible to remove the tank.
If the tank is not installed correctly, the tank full light
will come on, and the unit will not operate.
Do not remove or dismantle the fl oating element in the
tank. If it is removed, the unit cannot detect when the
tank is full, and this could result in leakage.
2010/05/17 10:28:16 2010/05/17 10:28:16