Kobalt SGY-AIR161 Manual page 14

ASSEMBLY INSTRUCTIONS
6. Connect air supply hose to the male plug. Set
the working pressure at 90 PSI for best tool
performance.
NOTE Working pressure refers to the air line
pressure set to tool when tool is under working
conditions.
3/8 IN. AIR RATCHET WRENCH
1. Remove the air inlet protective cap from the
air inlet (G2).
2. Mount a male plug by hand into the air
inlet (G2).
NOTE Use thread sealant tape on the male plug
and tighten it with a wrench (not included) for
airtight connection. Do not overtighten.
6
1
2
14