Plugging In The Printer; Running The Self Test - Epson LQ-2170 User Manual

Plugging in the Printer

1. Make sure the printer is turned off.
2. Check the label on the back of the printer to make sure the
voltage matches that of your electrical outlet.
Caution:
If the rated voltage and your outlet voltage do not match,
contact your dealer for assistance. Do not plug in the power
cord.
3. If the power cord is not attached to the printer, connect the
appropriate end to the AC inlet on the printer's rear panel.
4. Plug the power cord into a properly grounded electrical outlet.

Running the Self Test

You can run a self test on the printer in letter quality or draft
mode, with either continuous paper or single sheets. You can load
the paper from the rear, front, top, or bottom. The following steps
describe how to run the test on single-sheet paper, loaded from
the top. See Chapter 2 for more information on paper handling.
1-10 Setting Up the Printer