Table of Contents
Advertisement
6-6
Expansion Slot Setup
The SC828 chassis includes four slots for expansion cards.
Installing an Expansion Card (Figure 6-7)
1. Confirm that each expansion card includes a standard L-bracket.
2. Disconnect the power supply, lay the chassis on a flat surface and open the
chassis cover.
3. Remove the screw holding the slot cover in place for each slot you want to
populate. Keep this screw for later use.
4. Connect the expansion cards to the motherboard. Follow the expansion card
manufacturer's instructions.
5. Secure each card to the chassis using the card's L-bracket and the screw
previously removed.
6. Reconnect the AC power cord and close the chassis cover.
Figure 6-7: Removing the Expansion Card Slot Screw
Expansion Card
Expansion
Card Slots
Chapter 6: Advanced Chassis Setup
6-7
L-Bracket
Advertisement
Table of Contents
