Calibrating The Sensor Pen - Brother Innov-is VE2300 Operation Manual

USING THE SENSOR PEN

Calibrating the Sensor Pen

Before using the sensor pen for the first time, be
sure to personalize it using "Sensor Function
Calibration" in the settings screen. Doing so
allows the machine to learn the position in which
you usually hold the pen.
Hold the sensor pen at a comfortable angle and
then calibrate the machine according to the
procedure below.
Be sure to keep the sensor pen at the same angle
while calibrating the first and second points.
a
Press .
b
Display page 3 of the settings screen.
c
Connect the sensor pen to the machine and
then press
 The Sensor Function Calibration screen appears.
B-56
.
d
First touch the green dot marking on the
needle plate cover using the sensor pen.
* Touch on the needle plate cover.
a Needle plate cover
* A beep will sound and the a will change to red. (If
you cannot hear the beep, check that the volume
setting on page 1/7 of your settings is 1 or higher.)
* Press to redo the first point by starting over
d
from step .
e
Touch the second point at the center of the
cross-hair using the sensor pen.
* Touch on the point in the illustrations.