Making Embroidery Adjustments; Adjusting Thread Tension; Correct Thread Tension; Upper Thread Is Too Tight - Brother Innov-is VE2300 Operation Manual

MAKING EMBROIDERY ADJUSTMENTS

MAKING EMBROIDERY ADJUSTMENTS

Adjusting Thread Tension

When embroidering, the thread tension should be
set so that the upper thread can slightly be seen on
the wrong side of the fabric.

■ Correct Thread Tension

The pattern can be seen from the wrong side of the
fabric. If the thread tension is not set correctly, the
pattern will not finish well. The fabric may pucker or
the thread may break.
a Right side
b Wrong side
Follow the operations described below to adjust
thread tension according to the situation.
Note
• If the thread tension setting is made
extremely weak, the machine may stop
during sewing. This is not the sign of a
malfunction. Increase the thread tension
slightly, and begin sewing again.
Memo
• If you turn the main power to OFF or select
a different pattern, the thread tension will
reset to the automatic setting.
• When you retrieve a saved pattern, the
thread tension setting will be the same as
when the pattern was saved.

■ Upper Thread is Too Tight

The tension of the upper thread is too tight, resulting
in the bobbin thread being visible from the right side
of the fabric.
Note
• If the bobbin thread was incorrectly
threaded, the upper thread may be too
tight. In this case, refer to "Setting the
Bobbin" of "Basic operations" and rethread
the bobbin thread.
a Right side
b Wrong side
E-30
a
Press .
b
Press to weaken the upper thread
tension. (The tension number will
decrease.)
c
Press .

■ Upper Thread is Too Loose

The tension of the upper thread is too loose,
resulting in a loose upper thread, loose thread locks,
or loops appearing on the right side of the fabric.
Note
• If the upper thread was incorrectly
threaded, the upper thread may be too
loose. In this case, refer to "Upper
Threading" of "Basic operations" and
rethread the upper thread.
a Right side
b Wrong side
a
Press .