Sewing Embroidery Patterns; Embroidery Needle Plate Cover - Brother Innov-is VE2300 Operation Manual

SEWING AN EMBROIDERY PATTERN
Note
• Before embroidering, check that there is enough thread in the bobbin. If you start to sew your
embroidery project without enough thread in the bobbin, you will need to rewind the bobbin in the
middle of the embroidery pattern.
• Do not leave objects in the range of motion of the embroidery frame. The frame may strike the object
and cause a poor finish to the embroidery pattern.
• When embroidering on large garments (especially jackets or other heavy fabrics), do not let the fabric
hang over the table. Otherwise, the embroidery unit cannot move freely, and the pattern may not turn
out as planned.

■ Embroidery Needle Plate Cover

Under some conditions, based on the type of fabric,
stabilizer, or thread being used, there may be some
looping in the upper thread. In this case, attach the
included embroidery needle plate cover to the
needle plate. Attach the cover by inserting the two
projections on the underside of the cover into the
notches on the needle plate as shown below.
a Groove
b Projection
c Notch
To remove the embroidery needle plate cover, place
your fingernail in the groove and lift the plate out.
CAUTION
• Push the embroidery needle plate cover as far
as possible to attach it. If the embroidery
needle plate cover is not securely attached, it
may cause the needle to break.
Note
• Do not use the embroidery needle plate
cover for any applications other than
embroidery.
E-22

Sewing Embroidery Patterns

Example:
b
a Embroidery color order
b Cursor
Memo
• The [+] cursor moves over the pattern, showing
which part of the pattern is being sewn.
a
Thread the machine with thread for the first
color, pass the thread through the hole in
embroidery foot, pull out some thread to
give it some slack, and then lightly hold the
end of the thread in your left hand.
a